Workflow of stone production line/Problems that need attention for a reasonable stone production line
The supply of sand and gravel enables the rapid development of society. The raw materials required for the development of urban viaducts, expressways, highways and railways are processed by crushers, and can only be put into construction after the materials are qualified. So what problems should we pay attention to when configuring a reasonable stone production line?
Problems that need to be paid attention to when configuring a reasonable stone production line;
1. Raw materials
When designing a stone production line, the hardness, mud content, water content, silicon content and crushing work index of the material should be considered. Different materials have different equipment types.
2. Raw material size
The size of the raw material refers to the size of the material entering the primary crushing, which determines the selection of the primary crushing equipment.
3. Specifications, proportions and uses of finished aggregates
Different crushing equipment has different effects on the crushed products, and should be reasonably selected according to the actual production needs of users.
4. Output
Only when the output is accurate to the hour can the production line be selected accurately.
Workflow of stone production line
The general materials of the stone production line are quartz stone, limestone, etc. The production process of the sand production line is basically the same. The main process is as follows: the material is transported to the jaw crusher (PE jaw crusher is coarse, if the hardness of the stone is low, the coarse crushing can be omitted) for primary crushing; then it is sent to the impact crusher (cone crusher) for secondary crushing.